Why is My Vizio TV Not Turning On | Step-By-Step Fixes

If your Vizio TV won’t turn on, it usually comes down to a few common issues—power problems, remote issues, firmware glitches, or a failed internal component.

Try these step-by-step troubleshooting fixes:

Step-By-Step Fixes

✅ 1. Power Cycle (THE most common fix)

This resets the TV’s internal electronics.

1. Unplug the TV from the wall.

2. Hold down the power button on the TV itself (not the remote) for 15–20 seconds.

3. Plug it back in and try turning it on.

Why this works: It drains residual electricity and resets the power board.

✅ 2. Check the Power Source

• Make sure the outlet is working (test it with another device).

• If you’re using a power strip, try plugging the TV directly into the wall.

• Try a different outlet if possible.

Also Read : onboard.invalid Attestation Signature Twitter X

✅ 3. Check the TV Power Light

• Light ON but no picture: Backlight issue or screen failure

• Light flashes then turns off: Firmware or power board issue

• No light at all: No power → power board or cord failure (but try steps below first)

✅ 4. Remote Control Issues

Sometimes the TV is fine—the remote is the problem.

Try this:

1. Remove the batteries.

2. Hold the remote power button for 15 seconds (to discharge it).

3. Put in fresh batteries.

4. Try turning the TV on again.

Also try:

• Turning the TV on using the button on the TV, not the remote.

✅ 5. Check HDMI Devices & CEC

Sometimes devices like Roku, PlayStation, or soundbars cause the TV to get “stuck.”

• Disconnect ALL HDMI devices.

• Unplug the TV for one minute.

• Plug the TV back in and try turning it on without any devices attached.

✅ 6. Check the Power Cable

Vizio TVs sometimes have loose or detachable power cords.

• Make sure the cord is firmly pushed in on the back of the TV.

• Inspect the cord for damage.

• If the cord is removable, try replacing it (they’re inexpensive and common).

✅ 7. Try a Flashlight Test (to detect a bad backlight)

If the TV “turns on” but the screen is black:

1. Turn on the TV.

2. Shine a bright flashlight onto the screen.

3. If you can faintly see a picture → the backlight is broken.

This requires repair or replacement.

✅ 8. Factory Reset (if the TV at least shows a logo)

If the TV turns on but freezes or is stuck:

Hold the Volume Down + Input buttons on the TV for 10–15 seconds
→ You’ll see a reset prompt.

⚠️ When It’s a Hardware Problem

If none of the above works, the issue is likely:

• Power supply board failure

• Main board failure

• Backlight failure

• Loose internal connections

These are common on older Vizio models and usually cost $75–$150 to repair.