| Cellular
through remote control switch |
Definition
Cellular through remote control switch implies control of devices at a remote
location via circuit interfaced to the remote telephone line/device by dialing
specific DTMF (dual tune multi frequency) digits from a local telephone. This
project Cellular through remote control switch has the following features 1.
It can control multiple load (on/off/status each load)
2. It provides you
feedback when the circuit is in energized state and also sends an acknowledgement
indicating action with respect to the switching on of each load and switching
off of all loads (together). It can selectively
switch on any one or more loads one after the other and switch off all loads simultaneously
OPERATION 1.
Dial the Phone Number - a OK tone produced
2. Password - 4321
3. Load
number - 1, 2, 3, 4
4. Control number - 9/on, O/off, # / status When
the phone number is dialed the ring detector sense the ring and the auto lifter
works after some time. When the auto lifter works an OK tone is produced. Then
the password is entered. The password is 123451 Then to check the status of the
corresponding load enter # and load number. To on the load enter 9 and load number.
To off the load enter 0 and load number. The whole operation is done within 3
minutes. After 3 minutes the operation is timeout.
<<back |