Seminarsonly.com

 

 

Microwave Bandpass Filter

Abstract

The step- by- step advances in the ability to design and fabricate circuits at higher frequencies have produced a technology for the use of microwaves. Although there is no set definition for the microwave range, it is taken to be starting at approximately 1 GHz and extending to several hundred GHz. A planar circuit technology has evolved and become dominant for these circuits in this frequency range.

Early microwave equipments used rectangular waveguides and coaxial cables to interconnect bulky microwave devices, resulting in designs which were large and costly to construct. This began to change in the late 1940s and early 1950s, when the idea of using a flat strip of metal between two conducting planes as a waveguide for microwaves was conceived and promoted by R.M.Barett. Independently in 1942, a similar form of line was used by Wheeler. These evolved into strip lines.

 

 

 

 

Related Projects : : : Voting Machine,VHDL Modelling of Glue Logic of 1553b Interface Board,Variable Power Supply,Traffic Light Control System,Towers of Hanoi,The Nove DA,TENS Unit,TeleRemote,Telephone Triggered Switches,Telephone Router,Telephone Answering Machiner,SPEEDES Qheap,Speed Sensor,Service Channel Terminating Unit for Digital Microwave System,RTOS (VX Works) Based Control And Safety Monitoring,Radar Data Acquisition System,Packet Analyzer,Online Device Controller,Network Monitoring System Communication,Multiplier Accumulator Component VHDL Implementation,Multidimensional Visualisation System,Multi-Channel Infra Red Remote Control,Microwave Bandpass Filter,Microprocessor 8085 Trainer Kit,Microcontroller Based Cellular Voting Machine

   

 

 




 

 

 

 

 

<< back

 

 
All rights reserved ® Copyright © V2computers 2007 through 2017